Academic & Research
Access My Courses
Browse Teaching Resources
Circuits and Electronics
Measurements and Instrumentation
Full Course Set
Analog Discovery 2
NI ELVIS III
NI ELVIS II/II+
The Mathworks, Inc Simulink®
Analog Electronics Board for NI ELVIS
Analog Electronics Kit
Automated Measurements Board for NI ELVIS
Controls Board for NI ELVIS
DC Motor Board for NI ELVIS
Default Prototyping Board for NI ELVIS III
Digital Electronics Board
Emona Communications Board
Energy Systems Board for NI ELVIS
FOTEx Optical Communications Board for NI ELVIS
HVAC Board for NI ELVIS
Mechatronic Actuators Board for NI ELVIS
Mechatronic Interfacing Board for NI ELVIS
Mechatronic Prototyping Board for NI ELVIS
Mechatronic Sensors Board for NI ELVIS
Mechatronic Systems Board for NI ELVIS
myParts Kit for myDAQ
myRIO Embedded Accessory Kit
myRIO Mechatronics Accessory Kit
myRIO Starter Accessory Kit
Physics and Dynamics Board for NI ELVIS
Power Electronics Board for NI ELVIS
QNET Myoelectric Add-On Board
QUBE Servo Motor
Rotary Inverted Pendulum Board for NI ELVIS
SIGEx Signals and Systems Board for ELVIS
TETRIX PRIME Building System for myRIO
VTOL Board for NI ELVIS
by Dr. Nicola Femia | University of Salerno, and Texas Instruments
Students complete hands-on labs that cover the fundamentals of DC-DC linear regulators, DC-DC buck regulators, DC-AC inverters, and AC-DC rectifiers. Designed for NI ELVIS III.
by Enable Education
In this lab manual students simulate, build, and analyze circuits to learn about behaviors, characteristics, and applications of common silicon-based components. Designed for use with NI ELVIS III.
Introduction to Circuits
by Enable Education
This course covers the fundamental concepts of circuit theory and analysis through simulation in Multisim Live, and real-life circuit-building. Designed for NI ELVIS III.
In this lab students will be learning about the open-loop behavior and theory of an operational amplifier (op-amp) through hands-on applications. Designed for use with NI ELVIS III.
Kirchoff's Current Law
In this lab students will learn about Kirchoff's Current Law and how to calculate unknown values using KCL, then confirming with real circuits. Designed for use with NI ELVIS III.
In this lab students will be observing the use of thyristors in hands-on circuit simulation and circuit building. Designed for use with ELVIS III.
In this lab, students complete activities where they prepare measurement signals to be digitized. Designed for NI ELVIS III.
In this lab students will learn about resistor-capacitor circuits, make calculations, and confirm their understanding in hands-on circuit building. Designed for use with NI ELVIS III.
Introduction to DSSS (Spread Spectrum)
by Emona Tims
In this lab, students will recover a variety of messages from an amplitude modulated carrier signal and develop an understanding of the demodulation process. Designed for NI ELVIS III.
In this lab, students will learn about Ohm's law using circuit simulation in Multisim Live and hands-on application with NI ELVIS III. Designed for use with NI ELVIS III.